2012/2013 Yamaha R1 Race Bike for sale

Bkjohn

Member
I bought it off the original owner 2 years ago. I was planning on racing it, but ended up racing my GSXR600 instead. It has only been used a few times for track days.

Upgrades include:

- Sharkskinz fairings
- Graves Titanium Exhaust
- Flash Tune bike side harness
- Woodcraft Rearsets
- Ferodo ZRAC brake pads
- DID ERV3 520 Chain (-1, +2 gearing)
- GYTR Air Filter
- Driven Block Off Plates
- Spiegler steel braided brake lines
- Woodcraft brake lever guard
- Woodcraft frame sliders
- Woodcraft rear spools
- Woodcraft clipons
- Power Commander quick shifter
- Spare Sharkskinz front fairing

The bike is fully wired and would be techable with the EMRA, with one exclusion. The front axle pinch bolts need to be drilled for safety wire.

The bike has a non-repairable salvage title, but everything is straight as an arrow. The engine/transmission are from a 2013 and have 9511km on them. The ECU, traction control, dash, and forks are from a 2012. The bike was built from a salvage R1, stripped down to bare frame, cleaned, and all bearings, races, etc., were cleaned and lubed. The bike is immaculate from top to bottom, and nothing is out of sorts or out of place mechanically.

Asking $6500.00

Photos available on request
 
Last edited:
Top